Create strong bonds on plastic body panels, ground effects and spoilers with the Lord Fusor Plastic Bonding Adhesive (Slow) - 127EZ. This slow bonding adhesive works on binding several substrates - Metton, carbon fiber, SMC, fiberglass, and other plastics to itself and primed metal. This high-strength urethane structural adhesive works well for cab extenders, wood, glass, and other surfaces.
How to use the Lord Fusor Plastic Bonding Adhesive (Slow):
- Surface Preparation: Prime bare metal using a two-component epoxy primer. Let the primer dry completely and sand with 180 and 220 grit sandpaper. If it's a plastic surface, clean the area and sand the bonded areas with 80-grit sandpaper.
- Preparing the Product: Insert the two-component adhesive cartridge into the dispensing gun. Squeeze a small amount of adhesive from both sides of the cartridge to level the plungers and take care that the adhesive comes out from both sides. Fix a mixing tip and take out a small amount of material to check if the adhesive is properly mixed.
- Application: Apply a bead large enough (1/2" size) to fill gaps between the panel and the inner reinforcement. Use pressure to clamp panels and hold them in place while squeezing out a small amount of adhesive. Let the adhesive stand and completely cure. Cool to room temperature before unclamping. Prime and paint as per manufacturer recommendations.
Key Features of the Lord Fusor Plastic Bonding Adhesive (Slow) - 127EZ:
- High-strength structural assembly adhesive
- Non-sag formula
- Easy to gun
- 210 ml (7.1 oz) cartridge
- Can bond large body panels with a slow set formula that gives enough work time
- Resists extreme temperatures
- Does not contain VOCs, 100% solids
- OEM Approvals:
- GM: SMC panel replacement, meets GM6448G GM composite panel replacement
Technical Specifications
- Color: Brown
- Work Time: 50-60 minutes @ 70°F (21°C)
- Clamp Time:
- 4-5 hours @ 70°F (21°C)
- 30 minutes @ 140°F (60°C)
- Paint Time:
- 4 hours @ 70°F (21°C)
- 30 minutes @ 140°F (60°C)
- Full Cure Strength:
- 24 hours @ 70°F (21°C)
- 60 minutes @ 140°F (60°C)
Use with 1816423 Dispensing Gun and 1816424 Power Mixing Tips
WARNING:This product can expose you to Benzene a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
